Mounting for Starlink standard (new gen) dish on a motorhome roof. This mounting is designed to be bonded to the roof of your motorhome, the dish is then fitted into the mount & retained using the supplied clams on the corner & mid positions using the supplied stainless fasteners that fasten into metallic inserts in the plastic for strength. Available with standard hex drive fasteners, or for added peace of mind & even higher security, Torx head fasteners. The cable entry hole is nicely radiused to avoid damage to the cable & there is even a thoughtfully provided cable storage port that keeps water out of the ethernet connector should you remove the dish, rather than leave the end of the jack open to rain water damage. Should you wish to remove the dish from the mount, four finger recesses on the sides make this super easy, so you can actually get hold of the dish, unlike those that are fully flush where you have to lever the dish out, potentially damaging it. The seating area for the dish is angled to precisely match the angle on the housing, so avoiding damage to the dish housing from sharp corners. Finally, there is a drain point in each corner, so rain water will drain away no mater what angle your vehicle is parked at. Supplied in four sections that push together beautifully, no glue required as once bonded to the roof the sections will not come apart. Manufactured to order in White, Black or Grey UV resistant ABS-GF plastic. Available with standard hex drive fasteners, or for added peace of mind higher security Torx head fasteners.